Основная идея в том, чтобы прикрепить чехол штык-ножа с левой стороны PLCE сбоку к ватрботтл подсумку между аммо и ватрботтл - так он будет занимать минимум места и штык-нож всегда будет под рукой.
Например, кто-то делает маленькие дырки раскаленным шилом или острым ножом на боковой стороне ватрботтл подсумка, и при помощи штатной веревки/паракорда или стяжек закрепляет чехол штык-ножа сбоку на ватрботтл подсумке. Преимущества раскаленного шила/прооволоки в том, что края отверстий не будут рваться при использовании. Если используются стяжки (которые крепятся крест-накрест) - рекомендуют изнутри ватрботтл подсумка под них подложить кусок прозрачного пластика от упаковки из-под патронов.
1. Select one of the pouches with space to the side of it - mark appropriate "popper" holes to the outside of the pouch.
2. Make 2 small cuts in hte skin of said pouch.
3. Attach bayonet frog by putting the poppers through the holes previously cut.
4. Insert whatever you like into the bayonet frog
Вот тут чехол штык-ножа виден между подсумками:To stop the cable ties ripping the pouch put the little bit of clearish platsic from ammo cans inside the pouch under the ties. Helps stiffen the pouch and stop the bayonet bouncing around too.get sharp knife and place the frog against the side of your pouch in the position you want/need it. make small hole on either side and top/bottom get some thick cable ties and put one through top and bottom then one diagonal across. use a pair of pliers to pull them tight.
job done although for piece of mind i always used to tie para card through the frog and onto the black metal buckle on the pouch just incase anything broke or became loose etc
Кто-то просто пришивает 2 стропы сбоку на ватрботтл и крепит чехол штык-ножа штатными застежками на эти стропы:
Есть еще такой вариант:
То есть ремень PLCE только пропустить через петли левого аммо поуча и не закреплять их (не вставлять пластиковые косточки и не застегивать застежки), в результате между аммо поучем и ремнем PLCE будет свободное место, в которое помещается чехол штык-ножа. А уже чехол штык-ножа засовывается вертикально внутрь между петель аммопоуча и ремня и закрепляется на ремне PLCE, в результате чего удерживает от перемещения аммо поуч.When you put your ammo pouch on, only put the belt through the two loops and don't stick the black plastic tabs into the belt slots, this then leaves a perfectly sized space for your bayonet frog to be inserted between the pouch and the belt and when attached with the plastic tabs and poppers it also secures your ammo pouch in place perfectly. It can help to cut off the plastic tabs and velcro bits on the ammo pouch if it's a spare one and you don't mind experimenting, i certainly found it a great way to save space and also keep the bayonet in a very easily reached position.